[Hackrf-dev] Antenna trace cutting

[Adam Laurie]

Not sure where to post this as I'm a software guy, but if there's a 
todo/suggestions box for hardware this needs to be in it:

Cutting trace 44 to allow external antenna connection is way too fiddly. 
It's location makes it difficult to apply any force to 'cut' the trace 
without risk of damaging other components. I would suggest it either be 
a special location with a clear run for the knife (in this design that 
would be slightly closer to the antenna itself), or a proper header than 
can be jumpered as required.

cheers,
Adam
-- 
Adam Laurie                         Tel: +44 (0) 20 7993 2690
Aperture Labs Ltd.                  Fax: +44 (0) 20 8972 9377
Suite 117, Pegaxis House
61 Victoria Road
Surbiton
Surrey                              mailto:adam at aperturelabs.com
KT6 4JX                             http://aperturelabs.com
UNITED KINGDOM