[Hackrf-dev] Can I do that?

[Angus Findlay]

I'm planning to do something very similar once I finish moving into a new
house. We should connect back channel and collaborate. I've got a working
Lubuntu install which I've used to run through the first six of Mike's
lessons.
On Nov 7, 2014 5:06 PM, "pete M" <petem001 at hotmail.com> wrote:

> yup been following the lessons.. But I cant apply them yet.. cant run
> pentoo on any of my machine.. But will run ubuntu on one, waiting to have
> the time to install the whole thing by hands...
>
> just to let you know, Need the sweeping for tuning cavity's and duplexer..
>
> will use a rtl-sdr to read the signal and will tx with the hack rf.. will
> be able to set notch and band pass like that..  will see if it works ;-)
>
>
> > Date: Fri, 7 Nov 2014 16:50:28 -0700
> > From: mike at ossmann.com
> > To: petem001 at hotmail.com
> > CC: hackrf-dev at greatscottgadgets.com
> > Subject: Re: [Hackrf-dev] Can I do that?
> >
> > On Fri, Nov 07, 2014 at 06:37:28PM -0500, pete M wrote:
> > >
> > > BUT I do learn fast..
> >
> > You might like to start here:
> >
> > http://greatscottgadgets.com/sdr/
> >
> > I'm working on resuming lessons this month.
> >
> > > One other question.. can it also sweep in tx something like 7 mhz band
> > > of frquency very fast then start again all over and as long as needed?
> >
> > That is not a problem. There is some limitation to how fast the analog
> > front end (hardware) can be re-tuned, but that doesn't matter for
> > operations with a total bandwidth less than 20 MHz. A sweep over 7 MHz
> > can be done entirely in software without any requirement to re-tune the
> > hardware.
> >
> > Mike
>
> _______________________________________________
> HackRF-dev mailing list
> HackRF-dev at greatscottgadgets.com
> https://pairlist9.pair.net/mailman/listinfo/hackrf-dev
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist9.pair.net/pipermail/hackrf-dev/attachments/20141107/00461a54/attachment.html>