[Hackrf-dev] Internal shielding kit and headers

[David H Hickman]

I noticed a difference when using the radio for frequency coordination
from 450 - 700 MHZ.

The install was simple. However, taking the OEM case apart is a pain.  I
ended up making my case much less pretty due to marks where I pryied it
open.

Also take care on the solder, there are a few components close to where
the shield goes.

I am going to switch to a metal case once something like the ham-it-up
one becomes available.

--

dhh

On 9/15/2014 10:45, Stefan Wagener wrote:
> .... and on a similar note, is there another case available that gives
> access to the pin headers and might be even transparent. Anyone having a 3D
> printer and can make some?
> 
> Stefan
> 
> On Mon, Sep 15, 2014 at 7:13 AM, C Crane <ccrane148 at gmail.com> wrote:
> 
>> Apologies if this has been asked already but I purchased the internal
>> shielding and header jumper kit from nooelectric while waiting for the
>> HackRF to arrive. Is this kit still even necessary (shielding parts)? If
>> it's worth the effort of installing how does the plastic case come apart?
>> Does it snap together or are there screws under the corner feet?
>>
>> Thanks,
>>
>> Casey
>>
>> _______________________________________________
>> HackRF-dev mailing list
>> HackRF-dev at greatscottgadgets.com
>> http://nine.pairlist.net/mailman/listinfo/hackrf-dev
>>
>>
> 
> 
> 
> _______________________________________________
> HackRF-dev mailing list
> HackRF-dev at greatscottgadgets.com
> http://nine.pairlist.net/mailman/listinfo/hackrf-dev
>