[Hackrf-dev] Bandwidth control

[Karl Koscher]

When you are setting the bandwidth of the HackRF you are selecting which
hardware filter is used. I believe if you specify a bandwidth, it needs to
be one of the supported filter values -- 1.75, 2.5, 3.5, 5, 5.5, 6, 7, 8,
9, 10, 12, 14, 15, and 20 MHz.

On Mon, Nov 16, 2015 at 5:10 PM, 김상혁 <tkdgur7896 at gmail.com> wrote:

> I heard HackRF One support up to 20 MHz of bandwidth.
>
> But, I can’t handle this value properly. I tried to adjust bandwidth on
> GNURadio-Companion by changing some value o
>
> 1) Osmocom sink (Ch0: Bandwidth) - It was initialized by 0 and it means
> automatic setting. I vary this value but, never effect.
> 2) Modulation (Excess BW) - It means Root-raised cosine filter excess
> bandwidth (float) and usually range of ~ 0.35. When I change this value, it
> was little effect on bandwidth(larger value is more bandwidth)
> 3) Sample rate - I found that sample rate is directly related with
> bandwidth. I tried adjust this and it was so cool. When I use large value
> of amp_rate, however, the FFT plot graph was stutter. Is it computational
> problem?
>
> I’m curious to how to control bandwidth up to 20MHz.
>
> Thanks for any reply
>
> Shawn.
> _______________________________________________
> HackRF-dev mailing list
> HackRF-dev at greatscottgadgets.com
> https://pairlist9.pair.net/mailman/listinfo/hackrf-dev
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist9.pair.net/pipermail/hackrf-dev/attachments/20151116/10492e7b/attachment.html>