[Hackrf-dev] HackRF and Spyverter

[Gavin Jacobs]

Alejandro,
The Spyverter will shift the 457kHz signal up by 120 MHz, so the result will be 120.457 MHz. Connect your 457kHz signal to the input of the Spyverter; connect the output of the Spyverter to the rf input of the hackrf. Remember to apply 5Vdc to the Spyverter (make sure you use a linear power supply, or a battery pack, because a switch mode supply will be very noisy). You can use gnuradio companion (or numerous other programs) to show the spectrum.

Jake

________________________________
From: HackRF-dev <hackrf-dev-bounces at greatscottgadgets.com> on behalf of ALEJANDRO RAMIRO MUNOZ <100314975 at alumnos.uc3m.es>
Sent: April 25, 2018 2:36 PM
To: hackrf-dev at greatscottgadgets.com
Subject: [Hackrf-dev] HackRF and Spyverter

Hey all!

I'm writing this e-mail because I'm using HackRF-One SDR as a spectrum analyzer in a university project.

I'm also using a Spyverter converter (https://airspy.com/spyverter-r2/) and I'm having troubles to configure correctly the device, since I'm not very familiar with it.

I'm interested in detecting with the HackRF-One a signal which is at 457 KHz (out off the range of operation), therefore I need the Spyverter to achieve it, but I'm not able to configure it.

If you have some experience with this device used with a HackRF, or there's any website I can get some information about how to configurate it, I'll apreciate it a lot.

Thank you very much in advance,
Kindest regards,

Alejandro Ramiro.
--
Alejandro Ramiro Muñoz
NIA: 100314975

Grado en Ingeniería de Sistemas de Comunicaciones
(Bachelor's Degree in Communication System Engineering)

Universidad Carlos III de Madrid
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist9.pair.net/pipermail/hackrf-dev/attachments/20180425/99c16790/attachment.html>