[Hackrf-dev] Connect USB - Reset Required

[Dominic Spill]

Hi Jim,

Is this the device that you've managed to update firmware on and thus this
issue is now resolved?  Or are we talking about two different HackRFs here?

Thanks,
  Dominic

On Tue, 18 Sep 2018 at 08:35, James Brown <Jim at seti.net> wrote:

> Thanks for the information Dominic.
> I looked at the schematic for HackRF and did some testing on it. I decided
> that it was well and truly dead and not (by me at least) fixable.
> http://www.seti.net/engineering/engineering.php
> I guess I’ll be buying another HackRF!
>
> Regards Jim
>
> *From:* Dominic Spill
> *Sent:* Friday, September 14, 2018 13:30
> *To:* James Brown
> *Cc:* hackrf-dev
> *Subject:* Re: [Hackrf-dev] Connect USB - Reset Required
>
> Hi James,
>
> There are a couple of reasons that you might require a reset when
> connecting your HackRF.
>
> 1) USB power saving - this is enabled by default on many laptops and
> causes some issues with a device that has previously been connected.  You
> can disable this by following instructions here:
> https://github.com/mossmann/hackrf/wiki/FAQ#power-saving-and-usb-autosuspend
>
> 2) There was an issue with start up on some boards that caused them not to
> come up first time.  It primarily affected HackRFs from a specific
> manufacturing run and we were able to fix it in software.  The fix was
> included in our 2018.01.1 release here:
> https://github.com/mossmann/hackrf/releases/tag/v2018.01.1
> The fix is the only change between the 2017.02.1 and 2018.01.1 releases,
> so you can grab the binary firmware from the release archive and flash it
> without having to update your host tools.
>
> If you want to know more about the second issue, Mike wrote an in depth
> blog post on it:
> https://greatscottgadgets.com/2018/02-28-we-fixed-the-glitch/
>
> There could be other issues affecting your system, but these are the two
> that spring to mind immediately.
>
> Thanks,
>   Dominic
>
> On Fri, 14 Sep 2018 at 12:38, James Brown <Jim at seti.net> wrote:
>
>> Is there any reason a push of the reset button should be required when
>> connecting to the USB system?
>> Would a firmware update fix this?
>> Found HackRF board 0:
>> USB descriptor string: 0000000000000000285067dc2d0f3f4b
>> Board ID Number: 2 (HackRF One)
>> Firmware Version: 2017.02.1
>> Part ID Number: 0xa000cb3c 0x005c4f6a
>> Serial Number: 0x00000000 0x00000000 0x285067dc 0x2d0f3f4b
>> _______________________________________________
>> HackRF-dev mailing list
>> HackRF-dev at greatscottgadgets.com
>> https://pairlist9.pair.net/mailman/listinfo/hackrf-dev
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist9.pair.net/pipermail/hackrf-dev/attachments/20180927/8b7b1ff9/attachment.html>