[Hackrf-dev] Testing a new HackRF One

[Dan Koellen]

I had problems getting SDR# running with HackRF also.  I had been using SDR#
with a RTL dongle for a while with no problems.

Is there a newer version of SDR# I should install that will work with
HackRF?

I just imaged Pentoo and have to learn GNU radio now.   I was hoping to
bring HackRF up faster with SDR# that I am already familiar with.

-----Original Message-----
From: HackRF-dev [mailto:hackrf-dev-bounces at greatscottgadgets.com] On Behalf
Of mr2dave
Sent: Tuesday, August 12, 2014 11:26 PM
To: Jon B
Cc: hackrf-dev at greatscottgadgets.com
Subject: Re: [Hackrf-dev] Testing a new HackRF One

Try running zadig with hackrf plugged in.
>From the Options menu, select List All Devices.
Select HackRF One from the drop-down menu.
Verify that the WinUSB driver is loaded on the left. If it isn't,
install it again now.
If all else fails, load up Pentoo.


On Tue, 2014-08-12 at 20:59 -0600, Jon B wrote:
> I'm looking for a quick (Windows based way) to make sure the hardware
> works.
> 
> 
> I'm not sure my new HackRF One works.
> 
> 
> Anybody have any hints on how to configure SDR#?
> 
> 
> Here is what I've done:
> 
> 
> I attached the antenna to the antenna port.
> 
> I downloaded SDR#.
> I installed SDR#.
> I installed the driver by running zadig (the one from the sdrsharp
> directory).  
> Plugged in the HackRF One.
> Ran SDRSharp.
> Configured source = HackRF, Radio = NFM.  Then hit start.
> Set the frequency to 89MHz.
> 
> 
> I see a flat spectra spanning 86 to 96 MHz at -77.  As I roll around
> the spectrum I get nothing.
> 
> 
> The HackRF leds are all lit except TX.
> 
> 
> 
> 
> 
> 
> 
> 
> _______________________________________________
> HackRF-dev mailing list
> HackRF-dev at greatscottgadgets.com
> http://nine.pairlist.net/mailman/listinfo/hackrf-dev


_______________________________________________
HackRF-dev mailing list
HackRF-dev at greatscottgadgets.com
http://nine.pairlist.net/mailman/listinfo/hackrf-dev